View Single Post
Old 02-10-2013, 03:58 PM   #730
antc101
Registered User
 
Join Date: Jan 2013
Location: Potters Bar, England
Posts: 8
My Ride: 323ci (2000)
Here's a question, I did this retrofit the other day following using a complete morimoto mh1 setup. Although I need to open them back up to rotate the projectors a little, I noticed there is quite a bit of condensation in the headlight housing. I figured this would happen as while installing, I thought it was odd that there is no water tight seal on the rear of the housing after putting in the xenon bulbs.
Is there a proper way, or even a tried and tested method to seal the rear of the low beam housing? At the moment you can visually see the wires going in to the h1 with the retaining clip into the rear of the projector and I know this can't be good.

Cheers,
Ant
antc101 is offline   Reply With Quote