E46Fanatics - View Single Post - OEM M3 PARTS ON NON-M - modding guide
View Single Post
Old 02-21-2013, 06:16 PM   #631
Registered User
Join Date: May 2011
Location: Fresno, CA
Posts: 126
My Ride: 323 Ci
I recently installed an M3 hood on my 323 and am having some problems making minor adjustments. I've read the DIY's recommending to dremel the fender holes / mounting holes, cutting the rubber stop, and shave the sides, all which I have done. My problem is when I push the front of the fender in to lessen the gap, the other end near the firewall is impossible to pull out at all. I've tried different variations of which place I screw in and adjust first, but the other end wont budge in the opposite direction. So right now the front has a small gap while the rear has basically no gap. Can someone point me in the right direction? If I take my wheel off, is there another way to pull the rear of the fender out more?
Attached Thumbnails
Click image for larger version

Name:	P2210075.jpg
Views:	153
Size:	88.9 KB
ID:	491793   Click image for larger version

Name:	P2210076.jpg
Views:	159
Size:	84.5 KB
ID:	491794   Click image for larger version

Name:	P2210077.jpg
Views:	169
Size:	61.3 KB
ID:	491795   Click image for larger version

Name:	P2210078.jpg
Views:	187
Size:	47.4 KB
ID:	491796  

Click image for larger version

Name:	P2210072.jpg
Views:	204
Size:	148.9 KB
ID:	491797  
nissan00b is offline   Reply With Quote