View Single Post
Old 05-04-2013, 08:34 PM   #22
Registered User
Join Date: Mar 2013
Location: falls church, va
Posts: 73
My Ride: e46 M3
I tried to build the aux and input cable into the CD changer input, but no success. To tie into the input for the CD changer, I spliced into the cd changer harness wire that goes to the trunk, and used the cap/res (2x 0.22uF capacitors and 1x 300k Ohms resistor) to trick the unit into believe there is an input, but when I press the MODE button (I have an alpine unit s/n ending in 072), but had no success (got the "No CD" message, which I think is from the internal player not the changer).

Any thoughts? I've tried this wiring setup a couple of times with no success.
mattman928 is offline   Reply With Quote