OK, here is my status - I have NCS Expert working.
I coded the current LCM and the new to enable bi xenon with halogen for highbeams and to NOT turn off fogs when flash to pass or high beams…this thing is going to be a space ship with high beams on…
I reactivated the euro flashers
And on the new module the three blinks - BUT, I HAVE THE TAMPER DOT with the new LCM and couldn’t figure out how to get rid of it…I tried to go in through Progman to code a replacement but I couldn’t get progman to see more than 12.4v at pin 30…even with my huge/consistent charger with various settings for volts/amps (and this charger has worked with another persons progman before)
So, I have my original LCM in there right now.
I coded key controlled roll up of windows and folding with key mirrors and changed the max speed for which I can fold the mirrors - I can now do it while on the road instead of dead stop
I need to remember to turn off NAV accept (I had it before but with my meddling tonight I lost it)
So, left to do (that I can think of) is NAV accept, tamper dot removal (and checking coding on that LCM) and then hope that none of the automatic trans coding has seeped back in…ugh….