View Single Post
Old 07-26-2013, 01:28 PM   #570
Kris@TSS
Sponsor
 
Kris@TSS's Avatar
 
Join Date: May 2012
Location: Fresno, California
Posts: 571
My Ride: 2005 BMW 545i
Quote:
Originally Posted by SBPhil View Post
I'm getting clunking sounds from what I believe are the helper springs binding when I make a turn at low speeds. If I lift the car and remove the wheel the noise is practically gone when I steer, so I don't think its the assembly since I had it done at a shop. I ordered new FSMs since the shop recommended them and they are worn. Does anyone know if this will resolve it or do I need something else like a washer? The noise isn't as bad as the creak which is continuous as you turn, its only about 3 or 4 pops when I spin the wheel around. I'll try to get a video on my car tomorrow but its making this exact sound.



The issue they had was the assemble but I'm pretty sure that isn't it.
Aside from this, I would definitely say these coilovers are great for the money.
Any help is appreciated, thanks.
That video noise is the top mounts. My E60 did that when my top mounts were shot. Here is a link to read over about clunks that I created.
http://forum.e46fanatics.com/showthr...204&highlight=
__________________
Kristina "Kris" Ash
General Manager
The Suspension Source
1-888-230-1288
kristina@thesuspensionsource.com
www.thesuspensionsource.com
Kris@TSS is offline   Reply With Quote