View Single Post
Old 12-02-2004, 08:58 PM   #3
Moeser09
Registered User
 
Join Date: Aug 2003
Location: ATX
Posts: 62
My Ride: 2k1 M3
STEP FIVE

Put together the remote wire - see my thread for that (I'm too lazy to duplicate it).

STEP SIX

Plug all the female connectors into the socket until the snap into place - you should hear a click if you have it facing the right way. The bottom of the realy should have numbers next to the pins (30, 85, 86, 87 and 87a). You should arrange it so that you can determine which pin goes into which hole on the relay socket IT IS VERY IMPORTANT THAT YOU PUT THE RIGHT SPADES IN THE RIGHT PLACE ON THE RELAY SOCKET.

Put the positive terminal fuse holder into socket 87.

Put the negative spades (black wires) into socket 86

Put the green trigger wire into socket 85

Put the remote trigger fuse holder into socket 87a

Put the positive spades (red wires) into socket 30.

I put a zip tie at the base of the relay socket around the wires to hold them together.
Attached Thumbnails
Click image for larger version

Name:	5 Battery to Socket.JPG
Views:	2404
Size:	19.6 KB
ID:	100832   Click image for larger version

Name:	6 Neg to Socket.JPG
Views:	2366
Size:	19.4 KB
ID:	100833   Click image for larger version

Name:	7 ECU Trigger to Socket.JPG
Views:	2353
Size:	22.4 KB
ID:	100834   Click image for larger version

Name:	8 Remote Trigger to Socket.JPG
Views:	2345
Size:	21.5 KB
ID:	100835  

Click image for larger version

Name:	9 Pos to Socket.JPG
Views:	2349
Size:	21.2 KB
ID:	100836  
Moeser09 is offline   Reply With Quote