View Single Post
Old 06-24-2005, 02:10 AM   #10
MatWiz
Registered User
 
Join Date: Aug 2004
Location: Right Coast
Posts: 3
My Ride: BM
Quote:
Originally Posted by Pigeon
* Trace the wire to the connector way underneath the intake, disconnect it and remove the CPS from the car
* Run the new sensor's wire the same way the old one ran

Have fun!

Scott
Scott, or anybody else who did this?

How did you do this part?

I looked at this wire today as I was planing to replace mine, but the wire went down so low that I could not see the connection and could not see how I could even fit my hand down there.

Did you pull the wire up to bring the connection up to you? How do you fit your hand there???

Thanks!

Dan.
MatWiz is offline   Reply With Quote