View Single Post
Old 10-22-2002, 10:15 AM   #7
guest1016
fanatical
 
Join Date: Dec 1969
Location: .
Posts: 2,200
My Ride: .
Send a message via AIM to guest1016
when you hook up the output of your alpine to the wiring harness it goes directly into the amplifier, not the speakers. this is known as a high level input. Amps either take a hi-level (speaker level) or low-level (rca's)input Therefore your speakers will still be using the factory amp for power & crossover duties. There is nothing that will be doubly amplified. the Factory amps use high level input, VS. most aftermarket amps have input's for both. You have nothing to worry about just wire the plug up correctly and plug it in...
guest1016 is offline   Reply With Quote