DIY: UUC Pulley Install Enjoy!!
View Single Post
10-02-2005, 06:42 PM
Join Date: Jul 2004
Location: Boston, MA
My Ride: 88' BMW E30 SETA
View My Garage
Now it's time to install your new pullies. Installation is reverse
of removal. Once your pulleys are bolted back on and torqued to spec
(Really Low) start by reinstalling the the belts ONLY this time start
with your new belt route it through the pulley system exactly how the
old one was (Note: remember you will have to relieve the tension
again using what I recommend the 16mm socket. After you installed
your new belt go over to the AC tensioner and reinstall that belt
noting the same direction of rotation before it was uninstalled.
Once belts are back in place put back on the tensioner dust caps and
start installing the 32mm fan nut that needs to be torqued to 29 ft/lbs
. Once fan nut is in place reinstall the shroud and plastic fan.
Reconnect the 2 electrical connectors and put back on the T-25 or
T-20 bolt and the expanding rivet.
Done! It's that simple probably took me about 45 min to 1 hr to
install If you have any questions or comments feel free to PM me.
Oh BTW here are some pics of my old belt look at how cracked it was.
View Public Profile
Find more threads by Ivegotissues666
Find More Posts by Ivegotissues666
Leave feedback for Ivegotissues666 (17)