View Single Post
Old 05-02-2006, 10:03 PM   #21
mrdecibel
Registered User
 
Join Date: Feb 2006
Location: In a house
Posts: 21
My Ride: A car
Please visit: http://m3.madrussian.net/diy_valentine_v1.shtml

This is the DIY I followed to install my V1 and the PAC unit. The red wire will go to the green/blue wire. The black will go to screw holding motor bracket. The yellow goes to steering column. Between the DIY link I posted for the PAC and this one for the V1, you will be fine.

Good Luck.

Quote:
Originally Posted by sanman10535
On your PAC-SWI install, what color wires did you use for the sunroof install because I'm going to go that route? Does the black wire from the SWI suppose to connect to the ground (brown wire only) and where does the red SWI wire connect to? There seems to be a lot of red wires in the sunroof area but I can't seem to find the right one since they all aren't solid red.
mrdecibel is offline   Reply With Quote