View Single Post
Old 09-21-2007, 01:52 AM   #32
bluey
Registered User
 
Join Date: Apr 2003
Location: Edmonton
Posts: 53
My Ride: 325xi
Very helpful DIY, just swapped out mine tonight. Since I had an aftermarket intake, the replacement only took about 30 minutes or so.

One thing that I took out was the vent hose to ease entry to the sensor bolt, BUT if you do opt to do that make sure that you don't bend that hose too much or else it'll crack and break ... much like in my case. I had to duct tape it together. I hope that vent hose is not a critical system.
__________________
2001 325xi

Conforti CAI & Shark, Dinan Transmission Software, 6000K HID, 20% tint front, 10% tint rear, raised back up with Bilstein HD and stock springs (:'(), Rotora Stainless Steel brake lines, 18" OZ Alleggerita HLT w/ Sumitomo HTRZ III.
bluey is offline   Reply With Quote