E46Fanatics - View Single Post - DIY: Meyle Control Arms w/replaceable balljoints
View Single Post
Old 11-04-2007, 01:43 AM   #38
Registered User
Join Date: Oct 2007
Location: The Hauge, The Netherlands
Posts: 26
My Ride: E46 320I Touring
Well grafiksguy you got it right. Two month's ago I replace my CA bushings with OE bushingings and I had to replace them again a week ago. I have now Powerflex bushings placed and this installation is a walk in the park. I had a pair of Meyle Bushings ready in case this powerflex bushings were a PITA to install. Back then I installaled the OEM Bushing with a bit of WD40 to get this bushings on my CA, but as you said this will make the bushing slide over de CA and will not have a proper fix and after a few weeks they will break. So if you you place the OEM or Meyle CA bushings not the powerflesx just use a bit of water and soap and beat them with a hamer on the CA. Make sure your CA is clear of any dirt and grease.

Last edited by co3deron; 11-04-2007 at 01:46 AM.
co3deron is offline   Reply With Quote