E46Fanatics - View Single Post - DIY retrofit of multifunction (mfl) steering wheel
View Single Post
Old 02-05-2008, 03:58 AM   #3
Registered User
Join Date: Jan 2008
Location: Greece
Posts: 12
My Ride: 318ci valvetronic
Having done so we need now to take off the black plug in which we will install the last pin connector of our harness. It is the second one from left ot right, but in order to remove it we need to remove also the first one. If we take a close look at the plug we will see that it ia actually a holder that holds 2 smaller plugs inside it. In order to install the pin connector we need ti take it apart (as shown in pics )

We put the pin connector in pin 27 and put everything back together.

NOTE: in order to run the cable from the light switch to the control unit we pass it through an opening in the firewall located 20-30cm behind the small glove compartment.

THATS IT!!!!!!!!

The rest is just the reverse of the above procedure.

NOTE: when we put the steering wheel back together we should not forget to install the small cable that connects the buttons to the slip ring

here is a photo of the project finished

and here is a photo with cruise control light on

I hope this first post of mine in this forum to be helpfull !!!!!!

Last edited by StavKon; 02-05-2008 at 04:08 AM.
StavKon is offline   Reply With Quote