View Single Post
Old 09-08-2008, 10:06 AM   #8
TKC
Registered User
 
Join Date: Nov 2005
Location: San Jose, CA & Dallas, TX
Posts: 20,233
My Ride: 330cic & R6
Send a message via AIM to TKC
I would say the removal and re-install of the module was a 3 out of 10. The only hold up was unhooking the big yellow casing/rack that holds the module in place. Reaching the hooks at the top was a B!TCH! Other than that, it was really easy.

The Soldering portion, however, I would rate a 7 or 8 if you've never done that stuff before. PLUS, you really need the right equipment. Like I mentioned, I was lucky I had access to a tech shop that solders PCB etc... so I had the good stuff to make it easy.

Good luck!

at the eye comments. I took a pic while holding my glove box since I had it out, and then took a pic of the glove box when it was back in, and then merged the 2
Drunkenness
__________________
EUROPROJEKTZ - Director, NorCal Chapter
TKC is offline   Reply With Quote