11-30-2008, 11:38 PM
|
#18
|
|
Registered User
Join Date: Oct 2006
Posts: 31,536
|
Quote:
Originally Posted by Patman015
|
I actually didn't use a torque wrench at all for the entire process. I used a small ratchet and that's all. But I was very very careful not to over tighten the valve cover. There is a moderate amount of resistance as you tighten the valve cover onto the gasket, but after a little bit of that it gets a lot harder to turn and that's where I stopped. Maybe 10 ft/lbs for torque? Maybe less? 
|
|
|