View Single Post
Old 11-30-2008, 11:39 PM   #19
Patman015
Registered User
 
Join Date: Nov 2008
Location: Reisterstown, MD
Posts: 13
My Ride: 05 Honda S2000
Quote:
Originally Posted by mkodama View Post
I actually didn't use a torque wrench at all for the entire process. I used a small ratchet and that's all. But I was very very careful not to over tighten the valve cover. There is a moderate amount of resistance as you tighten the valve cover onto the gasket, but after a little bit of that it gets a lot harder to turn and that's where I stopped. Maybe 10 ft/lbs for torque? Maybe less?
i was gonna say yea...probably inch lbs lol
Patman015 is offline   Reply With Quote