E46Fanatics - View Single Post - Where to make this Aluminum piece?
View Single Post
Old 03-29-2009, 02:44 PM   #3
Registered User
Join Date: Feb 2007
Location: KY
Posts: 46
My Ride: 2007 911 carrera
Just a heads up that is going to be fairly expensive. I could cut it out of 3/8 stainless steel, I have a laser at my shop but that is the thickest it will cut... if you want it out of aluminum you will need to have it waterjet probably because most lasers don't cut aluminum all that well. But just material alone will probably be around 200 dollars, stainless price is about 1.50 a lbs and that would probably weigh 30-40 lbs plus the shop would have to buy a 4x4 sheet of material as well.
rjahr01 is offline   Reply With Quote