Its hard to say I had a bad rght lwr control arm bushing and balljoint and torn cv so I am replacing all the joints in the front end. both sides are apart. I also found a small chip off the chrome on the outer edge of the bearing race. I will post a pix soon.
don't wanna drop subframe. I was thinking of using the cyllinder the bolt threads into as my center. I was thinking of making a drill guide that slides over tubes and then I will have the right drill angle and close to center if not right on.A notched tube whose id matches the od of the mount.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
E46 Fanatics Forum
17.9M posts
592.5K members
Since 2001
A forum community dedicated to BMW E46, E90, and F30 owners and enthusiasts. Come join the discussion about M performance, turbo kits, engine swaps, builds, modifications, classifieds, troubleshooting, maintenance, and more!