E46 Fanatics Forum banner
Status
Not open for further replies.

Jake's HPF Built Motor w/6766 Upgrade

4K views 14 replies 13 participants last post by  lrinco01 
#1 · (Edited)
So Jake came in for same maintenance and 6766 upgrade, I wanted to show before and after results and we will have more pictures from Kris here in the next few days.



http://www.youtube.com/watch?v=FziEo7agrA8

Pump and Meth for the Win! :evil: We added about 2lbs of boost as well. For some reason the before run from last year didn't have boost referenced on it. :facepalm:

 
See less See more
2
#2 ·
Wow those are some great results
 
#3 ·
Wow what a nice gain for just a turbo upgrade!!
 
#4 ·
awesome numbers

sounds awesome too, hope mine is similar and makes similar power

niiice
 
#7 ·
The problem is everyone says it 'makes the same power, with the same this/that'... as what?.. a turbo on a different car, different motor, different manifold, different fuel? The 7275 supposedly spooled faster and made more power than the 7168.. until I swapped it in and found out it actually made the same power, and spooled slower. HPF has actually used a 6466 on a built low compression motor it wasn't as impressive as one would have thought (it was impressive comparatively but did not net the same results as it did on Larry's Supra if that's where you're getting your comparisons).. I still think the 6766 is a better choice for the S54.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top