Dynavin blowing up fuse 7

jtamba · 11-20-2010, 07:19 PM

I have a Dynavin unit installed last year. But last week I pulled it out to look at the connectors and put it back in right away. After that FUSE 7 has been blowing up. I've blown up 5 fuses so far by just replacing the fuse and starting my car. Anyone having this same issue? My dynavin of course is dead.

BusaNoob · 11-20-2010, 08:33 PM

when u pulled it out, u probably moved a bare wire around and now its making contact on the chassis, causing short and blowing fuse

jtamba · 11-20-2010, 09:01 PM

I'm gonna pull it out tomorrow and cover all the bare wires I can find and post the results. Thx

xi_ter · 11-20-2010, 09:45 PM

Or else metal on a connector is touching another connector. Good to have these connectors covered with the clear tubes supplied or else shrink wrap or tape.
There are a lot of connectors, I'd check out the clear tubes on the blue, gray and white wires.

11-20-2010, 07:19 PM	#1
jtamba Registered User Join Date: Oct 2010 Location: Orange County,CA Posts: 3 My Ride: 325i View My Garage	Dynavin blowing up fuse 7 I have a Dynavin unit installed last year. But last week I pulled it out to look at the connectors and put it back in right away. After that FUSE 7 has been blowing up. I've blown up 5 fuses so far by just replacing the fuse and starting my car. Anyone having this same issue? My dynavin of course is dead.

11-20-2010, 09:45 PM	#4
xi_ter Registered User Join Date: Nov 2006 Location: Edmonton, Canada Posts: 2,208 My Ride: 2003 325xi View My Garage	Or else metal on a connector is touching another connector. Good to have these connectors covered with the clear tubes supplied or else shrink wrap or tape. There are a lot of connectors, I'd check out the clear tubes on the blue, gray and white wires. __________________

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

11-20-2010, 08:33 PM	#2
BusaNoob Registered User Join Date: Aug 2008 Location: here Posts: 543 My Ride: AW 06 330ci ZHP View My Garage	when u pulled it out, u probably moved a bare wire around and now its making contact on the chassis, causing short and blowing fuse

11-20-2010, 09:01 PM	#3
jtamba Registered User Join Date: Oct 2010 Location: Orange County,CA Posts: 3 My Ride: 325i View My Garage	I'm gonna pull it out tomorrow and cover all the bare wires I can find and post the results. Thx