|
|
|
|
||||||
|
DIY: Do It Yourself
Post here to share or improve your wrench turning skills! All BMW E46 DIY tips, tales, and projects discussed inside. Learn to work on your car and know the right BMW parts you will need! |
 |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
06-03-2011, 11:37 PM
|
#1 |
|
Registered User
|
lease Help with Peak Codes Table 1b: 43 and b8
Hello,
I have been frustrated with the fault codes I have had for almost 2 years on my E46 M3 with no one with a solution. I have the following codes: Table 1b: 43 and b8 43: Intake camshaft VANOS advance valve b8: Intake camshaft VANOS position control I have replaced both the VANOS actuator and solenoid and I doubt it could be the VANOS exhaust sprocket, could it be something as simple as an intake camshaft position sensor? The car does run fine. It starts up perfectly and does not produce any weird noises. It is in limp mode. Thanks again.
__________________
 "Racing, competing, it's in my blood. It's part of me, it's part of my life; I have been doing it all my life and it stands out above everything else." ~ Ayrton Senna |
|
|
|
06-06-2011, 12:45 AM
|
#2 |
|
Registered User
|
Anyone?
__________________
"Racing, competing, it's in my blood. It's part of me, it's part of my life; I have been doing it all my life and it stands out above everything else." ~ Ayrton Senna |
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
