![]() |
![]() |
|
|
||||||
|
Lighting Forum
Angel Eyes, DDEs, lighted rings, Clear Turn Signals, LEDs, Xenon, HID, or Bi-Xenon. If it lights up and you want to discuss it, post here! |
![]() |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
|
#1 |
|
Registered User
|
Odd electrical reaction
Put in a pair of HIDs into my fogs a few months ago. This "issue" never bothered me, but I was just curious of what could be causing the hi beam indicator on the dash to quickly flash at the same time I turn the fog lights on.
Like I said, not a problem nor does it bother me, but just curious to see if they're wired in together somewhere in the electrical circuit.
__________________
![]() Last edited by DjZHP; 10-10-2012 at 04:51 PM. |
|
|
|
|
|
#2 |
|
Mod
|
LCM is not designed to handle xenon fogs, nevertheless without a wiring harness. Take that crap out before your fry a lot of things on your car.
__________________
Follow my cross country drive to Bimmerfest West 2013
http://forum.e46fanatics.com/showthread.php?t=987217 ![]() Youtube - Electric Fan Swap/Aux Fan Removal - Projector Retrofit - E46 Bulb Guide |
|
|
|
|
|
#3 |
|
Registered User
|
Ordered a whole new kit from DDM tuning with the wiring harnesses. Problem solved!!
Instructions:: Connect #4 and #5 to HID ballast Connect #1 to battery positive Connect #2 and #3 to ground Connect #6 to stock harness or the wiring from the HID bulb and then to stock harness Some harnesses some vary, but this is which wires are used... -Power -Ground -Two male plugs to ballast -One female to ONE factory wire, if the harness comes with an extra just tape it off.
__________________
![]() |
|
|
|
|
|
#4 |
|
Registered User
|
So in total it's only one harness you need and you will connect it to only one OEM foglight connector and leave the other one disconnected? I've been having the highs flag too.
__________________
- Christian
BMW M3 E46 | Carbon Black Metallic | Gray Nappa | ZCP | SMG | 40% Tint | LED Interior/Exterior Join Us at the San Diego North County Monthly BMW Meet ![]() Last edited by christiandflores; 02-06-2013 at 05:01 PM. |
|
|
|
|
|
#5 |
|
Registered User
|
|
|
|
|
|
|
#6 |
|
Registered User
|
Leave either #4 or 5 taped off on each side. You will need two wiring harnesses.
__________________
![]() Last edited by DjZHP; 02-06-2013 at 09:33 PM. |
|
|
|
![]() |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|