Loose window. Need help - Page 2

xmltok · 10-27-2005, 12:01 AM

dont take those 3 hex screws in the photo out though

ChrisMT79 · 10-27-2005, 12:36 AM

Quote:

Originally Posted by xmltok

dont take those 3 hex screws in the photo out though

No Im not going to take them out. But are those the ones that tighten the window?

xmltok · 10-27-2005, 01:25 AM

nope, those run perpendicular to the ones you want to tighten

take off the door panel and peel back the side of the foam near those bolts and you will find a hole that you will move the window up/down to align the bolt to

///Mechanic · 10-27-2005, 05:07 PM

Quote:

Originally Posted by xmltok

nope, those run perpendicular to the ones you want to tighten

take off the door panel and peel back the side of the foam near those bolts and you will find a hole that you will move the window up/down to align the bolt to

DO NOT TAKE THE DOOR PANEL OFF TO TIGHTEN/ADJUST THESE BOLTS!!!

It is the exterior trim that runs horizontal........geez.....

Open your door, and grab hold of the end of this molding closest to your door handle. Gently pull away from the door to pop the first clip out. Using your finger on one hand, slide it between the molding and the door to seperate the two pieces.......keep doing this until you have completely popped all of the clips (there are like 5 in all). You will see the holes in the door now, follow my steps above to adjust.

xmltok · 10-27-2005, 05:46 PM

thats all you had to say

ChrisMT79 · 10-30-2005, 09:58 PM

OHHH.. lol.. duh..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

10-27-2005, 12:01 AM	#21
xmltok UCLA Join Date: Oct 2002 Location: Los Angeles Posts: 1,204 My Ride: Boosted 330Ci View My Garage	dont take those 3 hex screws in the photo out though

10-27-2005, 01:25 AM	#23
xmltok UCLA Join Date: Oct 2002 Location: Los Angeles Posts: 1,204 My Ride: Boosted 330Ci View My Garage	nope, those run perpendicular to the ones you want to tighten take off the door panel and peel back the side of the foam near those bolts and you will find a hole that you will move the window up/down to align the bolt to

10-27-2005, 05:46 PM	#25
xmltok UCLA Join Date: Oct 2002 Location: Los Angeles Posts: 1,204 My Ride: Boosted 330Ci View My Garage	thats all you had to say

10-30-2005, 09:58 PM	#26
ChrisMT79 Here Join Date: Jul 2005 Location: Michigan Posts: 1,445 My Ride: Audi R8/BMW X6 View My Garage	OHHH.. lol.. duh..