|
|
|
|
||||||
|
DIY: Do It Yourself
Post here to share or improve your wrench turning skills! All BMW E46 DIY tips, tales, and projects discussed inside. Learn to work on your car and know the right BMW parts you will need! |
 |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
11-01-2008, 08:29 PM
|
#1 |
|
Registered User
|
Busted rear endlink - new swaybar?
I was changing my springs and busted the left rear endlink on the swaybar. I got the endlink screws off, but I can't get it off the bushing (disconnect it from the swaybar. Do I need to buy a whole new swaybar or does somebody know how to disconnect that endlink from the rear bar?
I read about the UUC, but I don't race, so I don't think that's necessary. |
|
|
|
11-01-2008, 08:41 PM
|
#2 |
|
Registered User
|
Pliers and a little muscle... Try spraying some wd-40 or silicone lubricant onto the bushing/bar where it slides off, grab it with some pliers and rotate it a bit to loosen it off the bar while pulling at the same time.
Shouldn't be difficult..
__________________
 The lesser we know...the more they fabricate...the easier it is to sell souls There is a new price on freedom, so buy into it while supplies last. We've unified over who to kill, so until I find more relevant scripture to quote... remember, our god is bigger, stronger, smarter, and much wealthier. So wave those flags with pride... It's the makeshift patriot. |
|
|
|
|
11-01-2008, 08:43 PM
|
#3 | |
|
Registered User
|
Quote:
  Welcome to DIY. It's always better when you do it yourself. $$$$$ 
__________________
 What makes you come alive?.........Go do it. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
