E46 Fanatics Forum banner

DSC Disabled by Pulling Fuse 61

52K views 27 replies 21 participants last post by  snowblocks 
#1 ·
We pulled Fuse 61 before my track day yesterday at PIR to disable DSC. This worked perfect and the ABS still worked. The DSC light always stays on after the fuse is pulled and the DSC never chops the throttle.

My E46 M3 is a 2002. I'm pretty sure this will probably work for all E46 M3's. Can someone else test this and verify?

Chris.
 
#3 ·
Interesting.
 
#13 · (Edited)
Pressing the DSC button once will only turn 50% of the system off.

Pressing and holding the DSC button until the light on the dash illuminates will turn the complete system off.

I wouldn't pull fuses out personally.
 
#21 ·
I know this is an old post, but needs a followup..

M3, disconnect front RIGHT speed sensor only, Wala, DSC and ABS and traction control off.. but still full power full rpm, and speedo works..
(can be done on ground, no lift or jack needed, takes 2 minutes!)

Took me a day of testing to get it figured out..

Pulling REAR SENSOR = NO SPEEDO :(
Disconnect master plug on abs it self = many codes errors, rpm limit, this and that..


Wanted to share... for others that find this here post when searching..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top