Just as topic says I managed to bend my floor under my lifting blocks by accidentally lifting the car with the jack a bit of the block close to the side skirt. This caused the block to collapse in on the outer side of the block can this be fixed? I can still lift the car fine by lifting it on the side that is not collapsed.
A body shop can access how easy or difficult it is to fix. You have to use the jack points properly or you will bend the unibody. There are quite a few threads on how to jack up the car. Here is one:
Well there is no hole it is just bent by 1-2cm max, sucks tough that **** like this happens .It is likely possible to bend it back but then there is the problem with metal fatigue which my cause it to bend more easily next time
It can be removed prolly have to brake it tough, Dont you guys think it can be bent back and function properly? Here is a picture, not the best one but you can see that lifting block is closer to the sideskirt than it should be.
I dont think there is a way to get to it from the inside of the car?
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
E46 Fanatics Forum
17.9M posts
592.5K members
Since 2001
A forum community dedicated to BMW E46, E90, and F30 owners and enthusiasts. Come join the discussion about M performance, turbo kits, engine swaps, builds, modifications, classifieds, troubleshooting, maintenance, and more!