Hi All. I am new to the forums but I did search extensively before posting.
I have a 2002 325i and the molding shown as #13 here:
http://www.realoem.com/bmw/showparts.do?model=ET37&mospid=47720&btnr=51_3267&hg=51&fg=20[/URL]
on the passenger side has been inching forward over time (now about 2"). There is now a gap (about 2" of forward travel) where part #14 usually is seated under #13 (referred to in the above link as well as picture #1). I am trying to figure out how to slide this back into place...or do I need to remove it?
As you can see from picture #2 it is traveling forward.
It obviously moved forward over time but sure doe not want to slide backwards....
I have been trying for some time to find the answer to this. If anyone has any suggestions I would appreciate the help.
I have a 2002 325i and the molding shown as #13 here:
http://www.realoem.com/bmw/showparts.do?model=ET37&mospid=47720&btnr=51_3267&hg=51&fg=20[/URL]
on the passenger side has been inching forward over time (now about 2"). There is now a gap (about 2" of forward travel) where part #14 usually is seated under #13 (referred to in the above link as well as picture #1). I am trying to figure out how to slide this back into place...or do I need to remove it?
As you can see from picture #2 it is traveling forward.
It obviously moved forward over time but sure doe not want to slide backwards....
I have been trying for some time to find the answer to this. If anyone has any suggestions I would appreciate the help.