05-18-2019, 02:02 AM
Join Date: Nov 2018
Location: Sweden, Jönköping
My Ride: E46 325ic
| Prepared for mac valve, ethanol sensor and fuel pressure sensor.
Hose and coupling that I should thread into the valve cover. 5/8 thread and an10 hose. This will go to a tank that I put next to the new washer fluid container. The second connection on the tank will be led to a t-pipe before the pump to evacuate the oil from the turbo.
There will be a gst 450 in the original tank that will fill a tank where there are two gst 450 pumps that will feed the fuel rail.
has not yet pressure tested the tank, but will do this before it is mounted. If it does not keep tight, I buy a Nuke tank.
Adapter and bearings mounted in the crank so that the box's axis is sufficient. 765 plates and zinter are also mounted.