Tune Wiki- How to configure/use Launch Control - E46Fanatics E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Go Back   E46Fanatics > Tuning & Tech > Driveline, Engine & DME Tuning

Driveline, Engine & DME Tuning
Talk about driveline improvements, NA tuning and DME tuning your E46 BMW here. This includes diffs, intakes, exhausts, chips, software and OBD tuning.

Reply
 
Thread Tools Search this Thread Rate Thread Display Modes
Old 02-24-2016, 02:02 AM   #1
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Tune Wiki- How to configure/use Launch Control

Hereīs an instruction on how to configure Launch Control (LC) at MS43 and use them:

1. Download the corresponding files in the google drive within the folder "Launch Control". Choose the one that matches your engine displacement. Also download xdf with LC in the description.

2. Flash the file with JMG

3. LC is preconfigured in TunerPro to have a bit of security. If you feel you need to tweak the settings download the tune with Galletto and open it in TunerPro.

4. Under "Special Functions: Launch Control" you can tweak the shown values. Description is available by hovering the mouse over each setting.



5. Save the bin and upload it using Galletto


Using LC

1. Make shure coolant temp is equal or above the treshold

2. Depress the clutch pedal

3. Choose first gear

4. Floor the accelerator pedal! (At least that °PVS matches the treshold!)

5. Engine speed should bounce at choosen rpm setpoint. There may be offset which engine speed bounces, like +/- 200rpm

6. Release clutch pedal while holding accelerator pedal down.

7. Engine speed will be reduced until vehicle speed exceeds choosen treshold

This feature, LC, wonīt make you a professional driver and it wonīt make your car a sports car! If the settings are tweaked to your cars drivetrain and your skills it can definately enhance your cars performance.

Warning:

If the engine does continue to increase rpm even with tweaked settings, you have one of very few weired DMEīs that we need to investigate further!
Check youtube for reference how its intended to work!

Development of LC is still going on so check back for the latest updates available!
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!
daniel_f. is offline   Reply With Quote
Old 02-26-2016, 07:37 AM   #2
thecos
Registered User
 
Join Date: Dec 2012
Location: NYC
Posts: 314
My Ride: 2002 325i Sedan
This is cool. I haven't flashed it yet but am willing to try it.

Once you flash LC will it always be active or is there some kind of activation sequence?
thecos is offline   Reply With Quote
Old 02-26-2016, 08:03 AM   #3
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Quote:
Originally Posted by thecos View Post
This is cool. I haven't flashed it yet but am willing to try it.

Once you flash LC will it always be active or is there some kind of activation sequence?
Its stated above your post
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!
daniel_f. is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 02-27-2016, 11:05 AM   #4
matt270avian
Banned User
 
Join Date: Nov 2015
Location: Keymar
Posts: 187
My Ride: 2002 325XI
I tried this yesterday. Made sure to drive around for about half an hour to ensure everything was up to operating temps, and then stopped in an isolated area. Clutch in, shifted to first and then matted the throttle. The engine caught at the RPM I set (2500) but then kept going past that point. Any ideas?
matt270avian is offline   Reply With Quote
Old 03-11-2016, 12:06 PM   #5
Elvin123
Registered User
 
Join Date: May 2011
Location: NYC
Posts: 653
My Ride: 328i
is this not possible on MS42?
__________________
Elvin123 is offline   Reply With Quote
Old 03-11-2016, 12:24 PM   #6
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Quote:
Originally Posted by Elvin123 View Post
is this not possible on MS42?
It may be done when i find a perfectly working solution.
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!
daniel_f. is offline   Reply With Quote
Old 03-11-2016, 09:05 PM   #7
Elvin123
Registered User
 
Join Date: May 2011
Location: NYC
Posts: 653
My Ride: 328i
This is exciting
__________________
Elvin123 is offline   Reply With Quote
Old 05-17-2016, 10:45 PM   #8
diablorojo
Registered User
 
Join Date: Oct 2008
Location: Houston, TX
Posts: 798
My Ride: Supercharged 330i
Daniel, can you quickly explain what each parameter is (PVS, Launch hysteresis, launch_tco_min, launch_vs_max)

Also, any suggestions for mph?

My boost is early so I'm looking at setting 2800 rpms but a little unclear on the MPH. I have lots of torque so im thinking the single digit mphs would still cause a lot of wheel spin ending the LC too early.

thanks...
__________________
Started ESS...ended CUSTOM!

Last edited by diablorojo; 05-17-2016 at 11:27 PM.
diablorojo is offline   Reply With Quote
Old 05-17-2016, 11:46 PM   #9
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Quote:
Originally Posted by diablorojo View Post
Daniel, can you quickly explain what each parameter is (PVS, Launch hysteresis, launch_tco_min, launch_vs_max)

Also, any suggestions for mph?

My boost is early so I'm looking at setting 2800 rpms but a little unclear on the MPH. I have lots of torque so im thinking the single digit mphs would still cause a lot of wheel spin ending the LC too early.

thanks...

Using LC

1. Make sure coolant temp is equal or above the threshold
2. Depress the clutch pedal
3. Choose first gear
4. Floor the accelerator pedal! (At least that °PVS matches the threshold!)
5. Engine speed should bounce at chosen rpm setpoint. There may be offset which engine speed bounces, like +/- 200rpm
6. Release clutch pedal while holding accelerator pedal down.
7. Engine speed will be reduced until vehicle speed exceeds chosen threshold

From the wiki
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!

Last edited by daniel_f.; 05-18-2016 at 02:55 AM.
daniel_f. is offline   Reply With Quote
Old 05-18-2016, 12:27 AM   #10
diablorojo
Registered User
 
Join Date: Oct 2008
Location: Houston, TX
Posts: 798
My Ride: Supercharged 330i
Lol, I know how to activate it but to set the parameters I (and those of us less experienced) need to know what each of the tables set.

1. Launch TCO - is this the target cooling temp?
2. Launch RPM MAX - is this the actual set point for the RPM (not to exceed and hold steady at XXXXX)?
3. Launch Hythersis - ?
4. Lauch vs Max - this is the MPH the car must reach before LC disengages?
5. Launch PVS - ?
__________________
Started ESS...ended CUSTOM!

Last edited by diablorojo; 05-18-2016 at 12:45 AM.
diablorojo is offline   Reply With Quote
Old 05-18-2016, 02:55 AM   #11
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Quote:
Originally Posted by diablorojo View Post
Lol, I know how to activate it but to set the parameters I (and those of us less experienced) need to know what each of the tables set.
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!
daniel_f. is offline   Reply With Quote
Old 05-18-2016, 10:08 AM   #12
diablorojo
Registered User
 
Join Date: Oct 2008
Location: Houston, TX
Posts: 798
My Ride: Supercharged 330i
Didnt mean to be confusing. Lol

What is Launch Hythersis and Launch PVS - ?
__________________
Started ESS...ended CUSTOM!
diablorojo is offline   Reply With Quote
Old 05-18-2016, 10:29 AM   #13
TerraPhantm
Registered User
 
Join Date: Feb 2008
Location: Philadelphia
Posts: 7,350
My Ride: M3 & ZHP
The launch hysteresis is basically how much the DME will let the revs drop before bringing them back up to the target. Based on daniel's instructions above, my guess is Launch PVS will be the minimum throttle position necessary to trigger launch control.
__________________
TerraPhantm is offline   Reply With Quote
Old 05-18-2016, 02:23 PM   #14
AndreBXP
Registered User
 
Join Date: Jun 2014
Location: Long Island, NY
Posts: 915
My Ride: '04 BMW M3
Funny enough, my XDF doesn't have the Launch Hysteresis parameter; is that a new feature?
__________________


Make This E36 Great Again! |Nexus 7 Headunit | How to Tune Your BMW| Youtube Channel

Maintenance > Mods. Straight 6 Enthusiast. Suspension built by Ground Control, tuned by Rob43.
AndreBXP is offline   Reply With Quote
Old 05-18-2016, 03:23 PM   #15
daniel_f.
Registered User
 
Join Date: Jul 2011
Location: Germany
Posts: 3,091
My Ride: 330iC
Quote:
Originally Posted by AndreBXP View Post
Funny enough, my XDF doesn't have the Launch Hysteresis parameter; is that a new feature?
Nope, its not used
__________________

Current licensing status:
Security implementation *done*
Implementing Flex Fuel

Siemens MS43 wiki!
daniel_f. is offline   Reply With Quote
Old 05-19-2016, 08:12 AM   #16
diablorojo
Registered User
 
Join Date: Oct 2008
Location: Houston, TX
Posts: 798
My Ride: Supercharged 330i
Thanks guys!!
__________________
Started ESS...ended CUSTOM!
diablorojo is offline   Reply With Quote
Old 05-24-2016, 02:00 PM   #17
ReneBMW
Registered User
 
Join Date: Oct 2008
Location: Poppel
Posts: 37
My Ride: e36 m3 euro
Cant wait till the m54b30 is in my e36��
How about the no-lift-shift feature, is it working and activated?
ReneBMW is offline   Reply With Quote
Old 05-25-2016, 12:56 AM   #18
sda2
Registered User
 
Join Date: Feb 2015
Location: Germany
Posts: 431
My Ride: BMW E46 330i Touring
Not implemented yet. ISAdelete is on priority right now
sda2 is offline   Reply With Quote
Old 06-30-2016, 02:08 PM   #19
Georg
Registered User
 
Join Date: Apr 2016
Location: Georgia
Posts: 23
My Ride: 330 with ms42
nice work guys
Georg is offline   Reply With Quote
Old 10-21-2016, 06:55 PM   #20
44chris
Registered User
 
Join Date: Sep 2016
Location: Germany - Heidelberg
Posts: 12
My Ride: E46 320ci
Quote:
Originally Posted by daniel_f. View Post
Nope, its not used
What does that mean? I also donīt have the hysteris in my xdf.. is there any way how i can get it?
44chris is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Censor is OFF



All times are GMT -5. The time now is 09:10 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
(c) 1999 - VerticalScope Inc. All rights reserved.