E46 Fanatics Forum banner

NCS GM5 problem with coding

1K views 0 replies 1 participant last post by  bakub94 
#1 ·
Hi guys,
i have problem with coding module GM5 in NCS Expert , car : BMW E46 2003.
I changed module comfort from LOW to HIGH , without problem i can read module GM5, but when i try to SG_CODIEREN empty MAN file or filled TRC file i get message:



I updated sp-daten to V66, my old module LOW i could normally write job sg_codieren...
I found some information that mayby there is VIN protection in module GM5 (?), unfortunatly i am newber in NCS Expert.

Thanks for any help or tips!
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top